Enerpac SFP-Series User Manual download pdf

L14004710 rev: preliminary F 03/07/14

1.0 SAFETY & GENERAL INFORMATION

Read all instructions, warnings and

cautions carefully. Follow all safety

precautions to avoid personal injury or

property damage during system operation.

Enerpac cannot be responsible for damage or injury

resulting from unsafe product use, lack of maintenance

or incorrect product and/or system operation. Contact

Enerpac when in doubt as to the safety precautions

and operations. If you have never been trained on

high-pressure hydraulic safety, consult your distribution

or service center for a free Enerpac Hydraulic safety

course.

Failure to comply with the following cautions and

warnings could cause equipment damage and personal

injury.

A CAUTION is used to indicate correct operating or

maintenance procedures and practices to prevent

damage to, or destruction of equipment or other

property.

A WARNING indicates a potential danger that requires

correct procedures or practices to avoid personal

injury.

A DANGER is only used when your action or lack of

action may cause serious injury or even death.

2.0 SAFETY PRECAUTIONS

WARNING: Stay clear of loads supported by

hydraulics. A cylinder, when used as a load

lifting device, should never be used as a load

holding device. After the load has been

raised or lowered, it must always be blocked

mechanically.

WARNING: use only rigid pieces to hold

loads. Carefully select steel or wood blocks

that are capable of supporting the load.

Never use a hydraulic cylinder as a shim or spacer in

any lifting or pressing application.

WARNING: Wear proper personal protective

gear when operating hydraulic equipment.

DANGER: To avoid personal injury keep

hands and feet away from cylinder and

workpiece during operation.

WARNING: Do not exceed equipment

ratings. Never attempt to lift a load weighing

more than the capacity of the cylinder.

Overloading causes equipment failure and possible

personal injury.

CAUTION: Do not connect a jack or cylinder

to a pump with a higher pressure rating.

Never set the relief valve to a higher

pressure than the maximum rated pressure

of the pump. Higher settings may result in

equipment damage and/or personal injury.

WARNING: The system operating pressure

must not exceed the pressure rating of the

lowest rated component in the system.

Install pressure gauges in the system to monitor

operating pressure. It is your window to what is

happening in the system.

OPERATING MANUAL

SFP SERIES

Index:

1.0 SAFETY & GENERAL INFORMATION ............ 1

2.0 SAFETY PRECAUTIONS ................................. 1

3.0 SPECIFICATIONS ............................................ 2

4.0 INSTALLATION ................................................ 3

5.0 OPERATION ..................................................... 4

6.0 MAINTENANCE ................................................ 5

7.0 TROUBLESHOOTING GUIDE ......................... 5

8.0 ATTACHED DOCUMENTATION TABLE ......... 6

1 2 3 4 5 6

Summary of Contents

Page 1 - OPERATING MANUAL

L14004710 rev: preliminary F 03/07/14 1.0 SAFETY & GENERAL INFORMATION Read all instructions, warnings and cautions carefully. Follow all safet

Page 2 - 3.0 SPECIFICATIONS

CAUTION: Avoid damaging hydraulic hose. Avoid sharp bends and kinks when routing hydraulic hoses. Using a bent or kinked hose will cause severe backp

Page 3 - 4.3 Hydraulic connections

4.0 INSTALLATION Visually inspect all components for shipping damage. Shipping damage is not covered by warranty. If shipping damage is found, notify

Page 4

4.4 Flow level Check the oil level of the pump prior to start-up, if necessary add oil by removing the plug from the top of the reservoir. The reser

Page 5

Now the machine is able to work. Use the manual valves to move the cylinders as explained in the paragraph 5.1. 5.4.2 Pumps with solenoid valves To t

Page 6 -    

7.1 Troubleshooting chart 8.0 ATTACHED DOCUMENTATION TABLE In this manual other documents have been attached which are necessary to interpret this man

Comments to this Manuals

No comments

Enerpac SFP-Series User Manual

Browse online or download User Manual for Pumps Enerpac SFP-Series. Enerpac SFP-Series User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Pumps Enerpac SFP-Series